Material brief

Asahi Kasei — Quick Specification

Purpose
Make the request specific

A compact fiber specification sheet

Quick specification — compare at least four dimensions
DimensionReview questionEvidence or next step
CompositionIdentify the named fiber or blend; distinguish Bemberg-related enquiries from a generic lining description.Request the material declaration and reference identifier.
Linear densityState dtex or denier and the nominal tolerance; do not mix count systems.Compare the same units and the same supply stage.
Supply formatSpecify filament, yarn or another documented form; identify package and quantity units.Confirm the offered format rather than assuming rolls of fabric.
Downstream processDescribe weaving, knitting, dyeing or finishing relevant to the proposed lining.For finished fabric only, add GSM, usable width and the tested finish condition.
Read the brief preparation guide

Make the material identifiable

Identify whether the request concerns fiber, yarn or a finished lining. Add the Bemberg-related designation only when it corresponds to the material being discussed, and attach the composition declaration or existing reference if available. A trade name cannot replace the material identifier. If the reference is a finished textile, explain what is known about its construction and finish; those details help distinguish an input-material question from a fabric-development question.

Use fiber composition and yarn count as distinct fields, and retain batch traceability where a reference lot is relevant. For lining colorfastness or dimensional stability, identify the finished specimen and the applicable procedure. A yarn package identifier cannot substitute for a test on the final construction.

Use units consistently

Use a stated count system for yarn and a relevant linear-density unit for fiber. Denier expresses grams per 9,000 metres; dtex expresses grams per 10,000 metres. Convert before comparing values, then keep the original unit in the record. These unit definitions are not an offered product range. For finished fabric only, specify GSM in g/m² and usable width with its unit; neither is a universal raw-fiber specification.

Explain the practical context

Describe the downstream operation: weaving, knitting, dyeing, finishing or a lining trial. Compare process suitability, supply presentation, composition and acceptance evidence as separate dimensions. Two references with the same nominal count may still differ in construction or finish. A sample-to-bulk check therefore needs an identified specimen and an agreed tolerance rather than a photograph. Ask which package format and order unit are relevant without presuming stock or a particular delivery route.

Send a focused next question

Choose the unresolved point that affects the next decision. If a dimensional-change result is being reviewed, state the fabric construction, care procedure, conditioning and report method. If linear density is the question, identify the input specimen and measurement basis instead. The procedure and sample state must travel with the result. No laboratory result is supplied here; testing conditions and acceptance criteria require agreement with the evaluating party.

Discuss this material question